Pair Transmitter
1Whilst in dive mode, press and hold the DOWN button for 2 seconds.
2Press the UP button to navigate right through the menu to Tank Pressure Pairing.
3Press the SELECT button to choose Tank Pressure Pairing.
4Press the SELECT button again to turn tank pairing on.
5As no code has been stored yet "-" will be shown. Press the SELECT button.
6Press the MODE button to get back to the dive display.
7"CD:--" tells you that the computer is now ready to receive tank pressure data. Should it not be shown press the DOWN button until it is.
8Start by pressurizing the first stage with tank pressure transmitter (The cylinder needs to have a pressure of at least 15bar/220psi.) Then check that the led of the transmitter is blinking. Finally take the computer close to transmitter (closer than 15cm/0,5ft away from each other).
9The transmitter icon will now start flashing in the bottom left hand corner and show the code it has received from the transmitter. After a few seconds the tank pressure will be shown.
NOTE: The pairing procedure only needs to be performed once, before the first use. You do not need to redo the pairing unless you change the transmitter to a new one, or another diver in your group uses the same code as you.
